11
9
93
I
9
5
9. IMPORTANT: To avoid damaging the Pulse
Crossbar (93), do not use power tools and do
not overtighten the #10 x 3/4" Screws (9).
Attach the Pulse Crossbar (93) to the right
handrail assembly (I) and the left handrail
assembly (not shown) with four #10 x 3/4"
Screws (9) and four #10 Star Washers (5) (only
one side is shown); start all of the Screws, and
then tighten them.
G
L
81
64
O
10
10. With the help of a second person, hold the
console assembly (L) near the console base
assembly (G).
Connect the wires (M) from the console base
assembly (G) to the wires (N) from the console
assembly (L). The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again.
Next, locate the console wire (O) in the con-
sole assembly (L). Connect the Upright Wire
(81) to the console wire. Then, insert the wires
(M, N) into the hole in the Console Base (64).
Insert the wires (O, 81) into the console assem-
bly (L), and position the wires on the decal.
M
N
To Next Page
Loading...
