4
16. Always remove the dumbbells from the
v
ibration platform before moving the vibra-
tion platform.
17. Use the vibration platform and the included
dumbbells only as described in this manual.
1
8. When connecting the power cord (see page
14), plug the power cord into an earthed cir-
cuit. No other appliance should be on the
same circuit. When replacing the fuse, an
ASTA approved BS1362 type should be fitted
to the fuse carrier. A 13 amp fuse should be
used.
19. If an extension cord is needed, use only a 3-
conductor, 14-gauge (1 mm
2
) cord that is no
longer than 5 ft. (1.5 m).
20. Keep the power cord away from heated sur-
f
aces.
21. Never leave the vibration platform unat-
tended while it is running. Always unplug the
power cord and press the power switch to
the off position when the vibration platform
i
s not in use. (See the drawing on page 5 for
the location of the power switch.)
22.
DANGER: Always unplug the power
cord when the vibration platform is not in
use and before cleaning the vibration plat-
form. Servicing other than the procedures in
this manual should be performed by an
authorized service representative only.
To Next Page
Loading...
Need help?
General
