Nordson 2302 - SECTION 2 Equipment Familiarization; 2. Standard Features Description

SECTION 2
Equipment Familiarization
1. Introduction
..........................................
2-1
2. Functional description of standard features
.................
2-2
Hot melt tank
.......................................
.2-2
Hot melt adhesive pump
.............................. .2-2
Distribution manifold
..................................
2-4
Tank, hose, and gun temperature controls
.................
2-4
Automatic gun hoses
.................................
2-5
Handgun hoses
......................................
2-5
Automatic extrusion guns (H20 and H200)
................ .2-6
Manual extrusion gun
.................................
2-7
3. Glossary
............................................
2-8
List of Illustrations
Figure 2.1 - Series 2300 Hot Melt Applicator
(Model 2305 Shown)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-1
Figure 2.2 -
Air-Driven, Dual-Acting Piston Pump
During Upstroke
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-3
Figure 2.3 - Air-Driven, Dual-Acting Piston Pump
on Downstroke .,.....................................
2-3
Figure 2.4 -
Model 2305 Indicator Panel with
Parent Machine Interlock (PMI) and Low Level Indicator Options. 2-4
Q Nordson Corporation 1994 P/N 106 7OlA
AU Rights Reserved
41-2300SP - Issued l/94