Specification Summary 9-T
4. Material safety data
information
(mtinlred)
VI. REACTIVITY DATA
Stability
Conditions to Avoid
lncompatability (materials to avoid)
Hazardous Decomposition Products
Hazardous Piolymerization
VII. SPILL OR LEAK PROCEDURES
Steps to Be Taken If Material Released or Spilled
Waste Disposal Method
VIII. SPECIAL PROTECTION INFORMATION
Respiratory Protection
Ventilation
Protective Gloves
Eye Protection
Other
IX. SPECIAL PRECAUTIONS
Precautions to Be Taken in Handling and Storage
X. NFPA 704M RATINGS
Health Hazard
1
Flammability
2
Reactivity
0
Other Hazards
None .
Stable
None
Strong oxidizers
None under normal conditions of use. Oxides of carbon
when burned.
Will not occur.
Dike and contain spill with inert material (sand, earth,
Fuller’s Earth, etc.) and transfer liquid and solid diking
materials to separate containers for recovery and disposal.
Wash floor with hot water and solution of “Oakite” or
equivalent. Remove contaminated clothing and wash
before reuse. Wash affected skin areas with soap and
water. Keep spill out of sewers and open bodies of water.
Incinerate liquid in approved equipment.
Landfill contaminated diking materials according to current
local, state and federal regulations.
None required for normal operations
Normal room ventilation
Impervious
Do not wear contact lenses.
Splashgoggles (ANSI 287.1,1979)
Eyewash facility
Impervious apron
Stainless steel and aluminum are acceptable for storage.
Recommended storage temperature is 8O’F (27X).
Material freezes below 41 ‘F (5%).
8 No&on Corporation 1994
All Rights Reserved
P/N 106 701A
41-23OOSP - issued l/94
To Next Page
Loading...
