7-14
Disassembly and Repair
Actuator assembly cleaning or
replacement
(continued)
&
0
0
\
l q@yD
Figure 7.36 - Upper Detent Screws.
Figure 7.37 - Bumper Assembly and Nut:
7 Bumper Assembly
2 Nut
5. Use a 3-mm hex key to remove the screws holding the upper detent
to the valve body. Remove the upper detent.
6. Place an adjustable wrench on the bumper assembly (1) and remove
the nut (2) with a 13 mm wrench. Set the bumper assembly aside.
7. Press the valve assembly out of the valve body with a socket or
similar object against the end of the sleeve (1). Do not press against
the end of the spool (2).
figure 7.38
- Valve Assembly and
Valve Body Details:
7 End of Sleeve
2 End of Spool
PIN 106 7018
41-23OOSP - Issued 10’95
BNordson Corporation 1994
All Rights Reserved
To Next Page
Loading...
