Ins talla tion
3-i
Section 3
Installation
1. Introduction
Section 3 contains information necessary for the proper installation of
the applicator, hoses and guns. Instructions for preparing the Series
2300 Applicator for operation, loading and changing adhesive and daily
operation are included in this section.
2. Unpacking
b
I
Figure 3.1- Hand Grip Locations
NOTE: Do not attempt to lift the applicator by any of the fiberglass
panels or hose connectors. Lift the unit from the hand grips in the metal
base (see Figure 3.1).
No special instructions are necessary to unpack the applicator, hoses
~ or guns. The applicator is shipped preassembled. Hoses and guns are
shipped separately, also preassembled. Normal care should be
exercised not to damage the equipment during unpacking.
3. Inspection
After unpacking is completed, the following inspection should be
performed:
1. Inspect the fiberglass cover for evidence of cracks and the other
surfaces for scratches, corrosion, or other damage.
2. Remove the electrical enclosure and inspect for loose electrical
connections.
3. Inspect hose for broken connectors, rips in the outer cover, and
evidence of kinks or other damage.
4. Inspect guns for loose mechanical and electrical connections and for
evidence of dents, scratches, and corrosion.
5. Inspect all fasteners and mechanical connections for tightness
0 Nor&on Corporation 1 QQ4
AU Rights Reservad
P/N 106 701A
41.2300SP - Issued llQ4
To Next Page
Loading...
