Nordson 3700V Series - Page 55

A 2-G Description
TanR The
tank melts
the adhesive
and holds it
until it is
pumped
to the
dispensing
guns.
With
its aluminum
construction,
cast-in heaters,
and
integral
melting
fins, the tank
is designed for
efficient
heat transfer.
A
strainer
in the tank
prevents
unmelted
adhesive from blocking
the
pump
inlet
when
you
fill the tank. lt
also
prevents
pieces
of cardboard and
other
small objects
from entering
the
pump.
The standard
tank is Teflon-coated
for
easy cleaning.
A non-coated
tank
is
available on some units.
Refer
to Specifications
in this
section for
the tank storage
capacity and
other key information
about the tank.
1
2
4
3
atanTAl
Fig.
A2-4 Key Parts
of the Tank
1. Tank casting
2. Strainer
3. Melting
fins
4. Heater
connectors
A2 EN-03-[3V-4-AXXVI-2
41
-3000v
lssued
2/99
Gr999
Nordson Corporatlon
All
rights reserved