Issued 4/98
1
237505b
Nordson Corporation
OPERATOR’S CARD
P/N 237 505B
Series 3500V/3700V
Hot Melt Material Applicator
with Piston Pump, Reverse-Flush Filter, Standard Control
Please Note
The operator’s card contains only information
necessary for daily operation and maintenance.
For other information, refer to the product manual.
A copy of this operator’s card and an order form for
another operator’s card are included in the
introduction part of the operating manual.
WARNING: Allow only qualified personnel to
perform the following tasks. Observe and
follow the safety instructions in this document
and all other related documentation.
S Always follow the instructions given in the
operator’s card and operating manual.
S Always follow instructions in the material supplier’s
Material Safety Data Sheet (MSDS) or material
information sheet.
S Even at recommended operating temperatures,
hot melt material may release vapors. Exceeding
prescribed processing temperatures for long
periods of time can result in dangerous
decomposition by-products. Remove vapors
by drawing them off with an exhaust system.
Safety Symbols
The following symbols warn against dangers or
possible sources of danger. Become familiar with
them! Failure to heed a warning symbol can lead to
personal injury and/or damage to the unit or other
equipment.
WARNING: Failure to observe can result in
equipment damage, personal injury, or death.
WARNING: Risk of electrical shock. Failure to
observe can result in personal injury or death.
WARNING: Disconnect equipment from line
voltage. Failure to observe can result in
personal injury or death.
WARNING: Hot! Risk of burns. Wear
heat-protective clothing, safety goggles, and/or
heat-protective gloves depending on the
symbol or symbols shown. Failure to observe
can result in personal injury or death.
WARNING: Pressurized system or material.
Release pressure. Failure to observe can
result in serious burns.
To Next Page
Need help?
General
