2
Part 7580607_01
E 2018 Nordson Corporation
Personal Safety
To prevent injury, follow these instructions.
S
Do not operate or service equipment unless you are qualified.
S
Do not operate equipment unless safety guards, doors, or covers are
intact and automatic interlocks are operating properly. Do not bypass or
disarm any safety devices.
S
Ensure the system is securely f ixed to the floor before operation.
S
Keep clear of moving equipment. Before adjusting or servicing, shut off
the power supply and wait until the equipment comes to a complete
stop. Lock out power and secure the equipment to prevent unexpected
movement.
S
Relieve (bleed off) pneumatic pressure before adjusting or servicing
pressurized systems or components. Disconnect, lock out, and tag
switches before servicing electrical equipment.
S
Ensure the powder pump has stopped feeding powder to the sieve prior
to removing the waste bucket/collector. Do not allow the waste powder
collector to overfill. Clean any excess/spilt powder immediately, using a
vacuum or cloth.
S
Obtain and read Safety Data Sheets (SDS) for all materials used.
Follow the manufacturer’s instructions for safe handling and use of
materials, and u se recommended personal protection devices.
S
Wear appropriate personal protective clothing including gloves and
breathing mask plus anything else recommended from the material
supplier and the SDS.
S
To prevent injury, be aware of less-obvious dangers in the workplace
that often cannot be completely eliminated, such as hot surfaces, sharp
edges, energized electrical circuits, and moving parts that cannot be
enclosed or otherwise guarded for practical reasons.
Fire Safety
To avoid a fire or explosion, follow these instructions.
S
Do not smoke, weld, grind, or use open flames where flammable
materials are being used or stored.
S
Provide adequate ventilation to prevent dangerous concentrations of
volatile materials or vapors. Refer to local codes or your material SDS
for g uidance.
S
Do not disconnect live electrical circuits while working with flammable
materials. Shut off power at a disconnect switch first to prevent
sparking.
S
Know where emergency stop buttons, shutoff valves, and fire
extinguishers are located. If a fire starts in a spray booth, immediately
shut off the spray system and exhaust fans.
S
Clean, maintain, test, and repair equipment according to the instructions
in your equipment documentation.
S
Use only replacement parts that are designed for use with original
equipment. Contact your Nordson representative for parts information
and advice.
To Next Page
Loading...