1
Nordson Corporation
OPERATOR’S CARD
P/N 1088668A02
Encore Manual Powder Spray System
WARNING: Allow only qualified personnel to perform the following tasks. Follow the safety instructions
in this document and all other related documentation.
Controller Interface
%
SCFM
M/HR
3
STD
K V
uA
AFC
E
NCORE
GUN CONTROLLER
Gun Triggered
Indicator
Select Charge
Modes
kV Setting
µA Setting
Help/Function
Display
Preset Select
% of Flow Air or
Flow Air Setting
Total Air Flow or
Atomizing Air Setting
Air Flow Units
Rotary Knob
Interface/Gun
Power On/Off
Setting/Function
Icons
Function
Button
Help Button
(View Help Codes)
View Button
(Hours, Software Versions)
Enter Button
Turning the Controller On and Off
Use the Interface/Gun Power Button to shut off the
interface and disable the spray gun.
Use the Power Switch on the controller power unit to
completely shut off the controller.
Changing Settings
To select a Preset or change a setpoint, press the
Preset Select Button or a Setting Button. The
button LED lights to indicate that it is selected.
Use the Rotary Knob to change the selected value:
clockwise to increase the value, counter-clockwise to
decrease. The values reset to the minimum if
increased past their maximum.
To Next Page
Need help?
General
