When the Softing CAN Interface
Manager appears (as shown),
select CLOSE.
Use Start>Run to browse for CANSetup.exe
located at
C:/iTraxBlueFlashDrive/softing_CANproUSB.
Run the file.
Install the Driver Software
Part 1607389-02 © 2019 Nordson Corporation
2
®
iTrax PC Replacement
4
3
2
Copying Flash Drive Files
NOTE: Before installing iTrax firmware or software,
copy the programs from the blue flash drive to the
new iTrax PC. The flash drive contains all of the
software needed to operate the iTrax system and
modules.
Create a folder on the C:/drive of the iTrax
PC. Name the folder “iTrax Blue Flash
Drive.”
1. Plug the flash drive in the USB drive
and navigate to its drive.
2. Copy all folders and files from the flash
drive to the iTrax Blue Flash Drive folder.
3. Verify that the contents of the newly
created folder match those from the flash
drive.
4. Properly remove the blue iTrax USB
flash drive and store in a safe place.
1
Locate flash drive or CD with the current
software. If the original software cannot
be found, contact your Nordson container
specialist.
Locate Flash Drive
Installing Software onto iTrax PC
To Next Page
Loading...
