EasyManua.ls Logo

Nordson iTrax - User Manual

Nordson iTrax
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
iTRAX
r
Remote Display
Customer Product Manual
Part 1076079A
Issued 11/07
NORDSON CORPORATION AMHERST, OHIO USA
For parts and technical support, call the Industrial Coating
Systems Customer Support Center at (800) 433-9319 or
contact your local Nordson representative.
This document is subject to change without notice.
Check http://emanuals.nordson.com for the latest version.

Table of Contents

Other manuals for Nordson iTrax

Preview: Customer Product Manual
Customer Product Manual20 pages
Preview: Quick Start Guide
Quick Start Guide6 pages

Questions and Answers

  • J
    jeffery56Aug 11, 2025
    What to do if actual backup time cannot be achieved on Nordson Desktop?
    • S
      smithlawrenceAug 11, 2025
      If the actual backup time on your Nordson Desktop is not being achieved, it could be due to several reasons. First, the battery voltage might be too low; in this case, charge the battery for at least eight hours. Another reason could be an overload; try removing some unnecessary loads, and ensure that the load matches the backup battery capability specified in the specifications. Finally, the battery itself may be defective, requiring a replacement.
  • W
    williamsderekAug 17, 2025
    Why is the backup battery always on battery mode on my Nordson Desktop?
    • W
      William HernandezAug 17, 2025
      If the backup battery is always on battery mode on your Nordson Desktop, the input may not be properly connected, so check the input connection. Another potential cause is an open input fuse.
  • B
    Brendan SnyderAug 22, 2025
    What to do if wrong gun address configured for Spray Monitor Nordson?
    • M
      michael55Aug 23, 2025
      If the Nordson Monitor displays an error indicating that the configured gun address is incorrect, ensure that the configured gun addresses align with the address switch settings located on the Spray Monitors. Verify and correct any discrepancies to resolve this issue.
  • S
    Sarah OliverAug 28, 2025
    Why Nordson Monitor doesn't receive CAN messages from Spray Monitors?
    • B
      Brandon JonesAug 29, 2025
      If the Nordson Monitor isn't receiving CAN messages from the Spray Monitors for 15 seconds, you should inspect the Spray Monitors themselves, the wiring connecting them, and the power supply to ensure everything is functioning correctly.
  • M
    Mark MurphySep 4, 2025
    What to do if no MODBUS frames received from PRx module for 15 seconds in Nordson Monitor?
    • S
      Sarah EdwardsSep 4, 2025
      If the Nordson Monitor isn't receiving MODBUS frames from the PRx module for 15 seconds, check the PRx module, its wiring, and the power supply.

Nordson iTrax Specifications

General IconGeneral
CategoryController
ManufacturerNordson
Protection RatingIP20
Communication InterfaceEthernet
Operating Temperature0°C to 50°C
Storage Temperature-20°C to 70°C
Humidity Range10-90% non-condensing

Related product manuals