Nordson iTrax - Data Configuration Procedure; Configuration

To Next Page

To Previous Page

iTRAX Remote Display

Part 1076079A

E 2007 Nordson Corporation

Data Configuration Procedure

This example sets the process value data to display:

1. Press the Select key to enter configuration mode. Press the Select key

to scroll through the configuration menu items.

2. On DATA press the Enter key.

3. Use the Up and Down Arrow keys to scroll through the data items.

4. Press the Enter key to select a data item. Yes appears if the item was

selected for display previously, No if it was not.

5. Use the Up or Down Arrow keys to toggle between Yes to display or No

to not display.

6. Press the Enter key to select Yes or No. SAVE appears, then

disappears and the data item name appears.

7. Use the Up or Down Arrow keys to scroll through the rest of the DATA

menu items.

8. Press the Select key to exit the DATA menu.

Configuration - PRx Module Data

Make the following required and optional settings to configure the Remote

Display to display PRx module data. See Figure 6 for the menu map.

Menu Function and Default

MODE Mode to enter: DISP (Display mode) or CONF (Configuration mode). Pressing the Select

key while in Display mode automatically sets the mode to CONF. Select DISP to return to

display mode from configuration mode. On power up the factory default is DISP.

INTR Display Interval (1-60 seconds): Time to display each process data value. If more than

one process data is selected, each data value is display for this time, in sequence.

Default is 5 seconds.

COMM Set communications protocol: CAN1, CAN2, 485 (RS485). Set to 485 for PRx modules.

The factory default is RS485.

DATA Process data to display: BASE (base pressure), TEMP (fluid temperature), RPM (belt

speed). The factory default is BASE only. If more than one is chosen for display, then

each is displayed in sequence.

NOTE: To configure the process data, refer to the Data Configuration procedure above.

UNIT Display units: ENGL (English) or METR (Metric). The factory default is English.

ADDR 1-4. The factory default is 2. The PRx module is always set to 1.

Nordson iTrax - Data Configuration Procedure; Configuration - Prx Module Data