iTRAX Remote Display
1
Part 1076079A
E 2007 Nordson Corporation
iTRAX Remote Display
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
WARNING: Make sure all equipment is rated and approved for the
environment in which it is used. Any approvals obtained for Nordson
equipment will be voided if instructions for installation, operation, and
service are not followed.
Description
The iTRAX Remote Display is used to monitor spray system operation. The
Remote Display can display process data for up to four iTrax Spray
Monitors or one iTrax Pressure Control system.
Spray Monitor Process Data
The Remote Display receives and displays process data from 1 to 4 iTRAX
Spray Monitors when the communication interface is configured for a CAN
bus. The operator can choose to display any or all of the following data
from each spray monitor:
S Base Pressure
S Fire Pressure
S Spray Duration
S Gun On Time
S Gun Off Time
Data selected for display is displayed sequentially, either by gun priority or
data priority.
PRx Module Process Data
The Remote Display receives and displays process data from the iTRAX
PRx module when the communication interface is configured for RS485.
The operator can choose to display any or all of the following data:
S Base Pressure
S Temperature
S Belt Speed
Data selected for display is displayed sequentially.
To Next Page
Loading...
