Nordson iTrax - Connect the Adapter

© 2019 Nordson Corporation Part 1607389-02
®
iTrax PC Replacement 3
7
8
USB-to-CAN adapter.
Connect the DB-9 connector to the
Connect iTRAX Modules
Turn power to the control unit ON.
5
6
Connect the supplied USB cable between
the computer and the USB-to-CAN
adapter. Wait for Windows to display the
notification that the CAN driver has been
installed successfully.
Connect the Adapter
Run setup.exe located at
C:\iTraxBlueFlashDrive.
Install the iTrax Software
Select both the iTrax OPC Server and
CanWorks iTrax Local Client when
prompted. Allow the iTrax installation to
complete. When prompted, reboot the
PC.