Nordson iTrax - Programming the Module

Part 1607389-02 © 2019 Nordson Corporation
5
®
iTrax PC Replacement
3
Shutting Down the iTrax Server
1. Once the operator interface is closed,
close the CanWorks OPC Server.
2. Verify that there are no active iTrax
application icons on the taskbar.
4
NOTE: If selecting all modules, select All (8) to
quickly select all in the list.
7. Select All at Once (5) to allow all
selected modules to update
2. Select the Nordson CAN Programmer
icon on the iTrax PC Desktop to open the
CAN Programmer main screen.
1. If the iTrax modules are OFF, power the
modules ON. If the iTrax modules are ON,
cycle the power OFF and back ON.
3. Select iTrax Monitor from the
list box (6). Once selected, the module
address listing (7) will show all of the iTrax
monitors in the system. The list displays
each module’s current software version
and serial number.
Programming the Module
4. Navigate to C:/JTAG/iTraxSM (2)
folder.
5. Select the S-record file iTrax0520.S (1)
and the file name appears in the location
field (3).
6. Select the modules to be updated in the
module address listing (7).
1
2
7
6
5
4
3
8