Options
10-4
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
Option in configuration
code
Box Also
available
as
accessory
Description
Host communication 19 − D: PROFIBUS DP
N: ControlNet
E: EtherNet/IP
X: Standard IPC
Separate line speed signal
inputs
20 − K: Every motor receives its own line speed signal.
Casters 21
C: To move melter; two can be locked
Inert gas equipment 22 − G: Used to blanket tank contents with inert gas.
This is needed when processing certain materials.
Filter cartridge / safety valve 23
C: 0.8 mm filter with 85 bar safety valve
D: 0.2 mm filter with 100 bar safety valve
G: 0.8 mm filter with 100 bar safety valve
X: 0.2 mm filter with 85 bar safety valve
Spare 24 −
26
− −
Drain valve 27
D: The drain valve is used to quickly remove the
material from the tank.
Inputs for external pressure
display
28
#: The unit can receive and process signals from
external pressure sensors.
Heat exchanger 29 − E: The heat exchanger serves to maintain a
constant temperature in the electrical cabinet.
Motor circuit switch
(Service or repair switch)
30 − M: Lockable motor circuit switch. Motors can be
deenergized. Additional contact for triggering by
control system.
Gun solenoid valve 31 − G: 24 V
DC
is supplied for the gun solenoid valves.
The voltage is controlled via standard I/O.
ACM Connectivity
(ACM = Auxiliary Control
Module = additional electrical
cabinet)
32 − 1: One or two separate electrical cabinet(s) (with
additional motor and temperature channels) can be
connected and controlled.
Programmable controller
(PLC)
33 − B: A-B ControlLogix with ControlNet and PanelView
C: A-B ControlLogix with EtherNet/IP and
PanelView
D: A-B ControlLogix with DataHighway
+
and
PanelView
Spare 34 −
36
− −
To Next Page
Loading...
