Nordson Smart Gun - User Manual

Questions and Answers

B
brian76Aug 12, 2025
What to do if Nordson Industrial Equipment Smart Gun will not dispense?
- J
  James SanchezAug 12, 2025
  If your Nordson Industrial Equipment Smart Gun isn't dispensing, several factors could be at play. Start by checking for blockages in the material path, ensuring that material is flowing freely through all hoses. Also, verify that your supply equipment is cycling correctly by confirming sufficient air pressure, referencing the supply equipment literature for guidance. If the issue persists, inspect the connection air lines connected to each integrated valve. Ensure the power and controller connections are properly fastened. Make sure there is sufficient power supply to the material supply and it is supplying the proper material supply pressure, referencing the material supply equipment literature.
D
Dale CarterAug 22, 2025
Why is my Nordson Industrial Equipment Smart Gun leaking?
- A
  Allison DickersonAug 22, 2025
  If your Nordson Industrial Equipment Smart Gun is leaking, start by checking for loose fittings or gauges and tighten them as needed. If the leak persists, it could be due to valve seal failure, in which case you should replace the seals. If the needle or sealing face is scored or damaged, replace or repair them as necessary. Also, ensure all fittings on the Smart Gun material manifold are properly tightened and that the swivel assembly has sufficient grease. If the leakage continues, replace the seals in the swivel assembly, including those between the swivel assembly and the Smart Gun assembly.
J
jennifer38Aug 30, 2025
How to fix Nordson Industrial Equipment Smart Gun stiction?
- C
  Courtney ChristianAug 30, 2025
  If you're experiencing stiction with your Nordson Industrial Equipment Smart Gun, avoid leaving the gun idle under material pressure for extended periods; ensure pressure is purged regularly. You can also try placing the Smart Gun over a bucket and rapidly actuate it for 20 to 30 cycles to resolve the issue. Check that the air pressure is correctly set and that there are no blockages in the Smart Gun's air hoses or solenoid valves. If these steps don't work, consider replacing the Smart Gun valve cartridges.