What to do if my Nordson Industrial Equipment shows undertemperature?
If the actual temperature of the component has dropped below the undertemperature delta, which was set using parameter 22, check whether external factors have caused the ambient temperature to fall or replace the RTD.
What to do if my Nordson Industrial Equipment shows overtemperature?
If the actual temperature of the component has increased beyond the overtemperature delta, which was set using parameter 21, replace the RTD.
What to do if Nordson Industrial Equipment shows 'Main board feedback' error?
If there is a communication failure between the main board and the processor, replace the main board, ribbon cable, or CPU.
What causes 'Analog-digital calibration' error on Nordson Industrial Equipment?
If the RTD analog-digital converter could not be calibrated, replace the main board, ribbon cable, or CPU.
Why does my Nordson Industrial Equipment show an Analog-digital error?
If the RTD analog-digital converter has failed, replace the main board or CPU.
How to fix a Thermostat error on Nordson Industrial Equipment?
If there is an open reservoir, grid, or hopper thermostat, replace the thermostat, cable harness, or main board.
What causes 'Optional I/O expansion board' error in Nordson Industrial Equipment?
If there is a communication failure between the processor and the optional I/O expansion board, replace the I/O expansion board or CPU.
What causes 'Field bus communication failure' in Nordson Industrial Equipment?
If there is a field bus board failure, replace the field bus board.
How to fix RAM Test failure on Nordson Industrial Equipment?
If there is an internal RAM failure, replace the CPU.
What to do if Nordson Industrial Equipment shows 'Realtime clock Time' error?
If there is an internal clock failure, replace the CPU.
Explains the meaning of safety alert symbols and signal words.
Guidelines for safe installation and operating practices.
Safety practices for maintenance and equipment shutdown.
Lists general hazards and essential safety precautions.
Emergency procedures for contact with hot melt material.
Defines the product's intended application and operating restrictions.
Identifies unavoidable dangers and defines key terms like Inert Gas.
Procedures for making safe electrical and signal connections.
Procedure for the first startup and purging the melter.
Overview of the control panel and setting operating parameters.
Managing heated components and adjusting setpoint temperatures.
Warnings for burns and procedures for relieving system pressure.
Initial checks, fault number tables, and common error codes.
Diagnosis for F1, F2, F3, and F4 faults.
Tables addressing issues like 'Melter not Functioning' or 'No Material'.
Essential safety warnings before performing repair work.
Step-by-step guides for replacing the pump and motor.
Setting up schedules for automated operation.
General| Brand | Nordson |
|---|---|
| Model | PURBlue EC |
| Category | Industrial Equipment |
| Language | English |
To Next Page