Operation
4-7
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Helpful Information
S You can exit Setup mode at any time by pressing the Setup key.
S If no key is pressed for two minutes while in Setup mode, the melter will
return to Normal mode.
If password protection is enabled, the system will return to the password
protected mode.
S Parameter numbers that are reserved (not applicable) are skipped when
scrolling through the operating parameter list in the left display.
S When the right display is flashing, you can quickly set the value of the
current parameter to its lowest possible value by simultaneously
pressing both of the right display scroll keys.
S For information on the serial interface (5, Fig. 4-3), refer to Appendix C.
To Next Page
Loading...
