25 mm
max
Operation
4-4
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Filling the Tank
CAUTION: Cease operation before the tank is completely empty. If there is
too little material in the tank, the material can overheat. Overheated material
can char, collect on surfaces and cause malfunctioning.
Ensure that no material is blocking the inert gas inlet.
WARNING: Hot! Risk of burns. Wear appropriate protective
clothing/equipment. Tank and tank lid are hot. When filling, hot material may
splash out of the tank. Use caution when filling tank with material.
CAUTION: Before filling the tank, ensure that the tank and material are
clean and free of foreign substances. Foreign substances can hinder
functioning or even cause damage to the melter or accessories.
Fig. 4-1
Maximum Level
The level should not exceed 25 mm (1 inch) under the inert gas inlet (max).
Adapt the maximum level to the material dispensing speed. Feed materials
sensitive to temperature quickly to prevent loss of quality.
Fig. 4-2 Hopper
To Next Page
Loading...
