Nordson PURBlue EC - Upgrading or Restoring Melter Firmware

Melter Communication
C-6
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Upgrading or Restoring Melter Firmware
Use the NCM to upgrade your melter firmware to a newer version or to
reload the current firmware version. The currently available firmware version
can be downloaded from www.enordson.com/support.
NOTE: The firmware version installed on your melter appears on the
control panel when the melter is switched on.
The current melter settings are downloaded and saved on your PC when an
upgrade is performed. When the melter firmware has been upgraded or
restored, the pre-upgrade settings can be restored with the NCM.
CAUTION: The melter settings are returned to the defaults when an
upgrade is performed. Only the hours of heater operation are saved. The
contents of the fault log and the change history log are lost when the
firmware is upgraded.
Upgrading or Restoring Melter Firmware
1. Connect the PC to the melter. Refer to Linking PC and Melter earlier in
this section.
2. Put the melter in upgrade mode. To do this, hold down the Setup key
and the left display scroll key, and switch the melter off and then on
again.
UPLOAd appears in the right display.
3. Double click on the NCM icon on the Windows desktop.
The Configuration Manager dialog box appears.
4. Click on Select Device.
The Select Product dialog box appears.
5. Select DuraBlue from the list, then click on OK.
The Select COM Port dialog box appears.
6. Select the COM port used for the connection to the melter, then click on
OK.
The PC and the melter establish communication, and an image of the
selected melter appears in the melter status area. The right side of the
status area indicates CONNECTED.