Nordson PURBlue EC - Section 4 Operation

Operation
4-1
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Section 4
Operation
WARNING: Allow only qualified personnel to perform the following tasks.
Observe and follow the safety instructions in this document and all other
related documentation.
Modes
S Normal mode
Recognizable by scan cycle.
S Key-to-line
S Manual mode
S Standby
S Setup mode
Auto-scan
The actual temperatures of the heated components are displayed if their
setpoint temperatures are greater than zero degrees. The sequence of the
automatic scan is:
Left display Component Note
b
Empty Reservoir *)
b
1 Hose 1
b
1 Gun 1
b
2 Hose 2 If present
b
2 Gun 2 If present
b
5 Band heater (hopper)
b
Empty Reservoir
b
1 Hose 1
b
... ...
*) The actual temperature of the grid must be checked manually; refer to
Check Actual Temperature Manually − Helpful Information.