Nordson PURBlue EC - Notes on Cardan Joint

Maintenance
5-2
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Notes on Cardan Joint
The Cardan joint can be extended from L
total min
= 200 mm to
L
total max
= 210 mm. Maximum angle of each joint = 45°.
Important when Using Cleaning Agents
S Never used halogenated hydrocarbon solutions to clean components
made of aluminum or to purge Nordson equipment. The strong chemical
reaction can cause injury or death. Also refer to section Safety.
S Use only a cleaning agent recommended by the hot melt material
manufacturer. Observe the Material Safety Data Sheet for the cleaning
agent.
S Properly dispose of cleaning agent according to local regulations.
Processing Materials
Designation Order number Use
High temperature grease To be applied to O-rings, threads
and sealing surfaces
S Can 10 g
P/N 394769
and sealing surfaces
N
O
TE: Th
e
g
r
ease
m
ay
n
o
t
be
S Tube 250 g
P/N 783959
NOTE: The grease may not be
mixed with other lubricants.
Oily/greasy parts must be cleaned
S Cartridge 400 g
P/N 402238
Oil
y
/
greasy par
t
s mus
t b
e c
l
eane
d
before they are used.
Temperature-resistant
adhesive Loctite 640
Secures screw connections
S 50 ml
P/N 230359
Heat transfer compound
NTE303
To improve heat conducting of
temperature sensors
S 1 g
P/N 1023441