Operation
4-19
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Quick Adjustment − Tips −
S When the right display is flashing, the setpoint temperature can quickly
be set to 0 degrees (Off) by simultaneously pressing both of the right
display scroll keys.
S When a setpoint temperature is set with the right scroll keys, the right
display automatically jumps from 0 to 175 or 230 _C or from 0 to
350 or 450 _F.
Helpful Information
S If you make a mistake while changing a setpoint temperature but have
not yet pressed the Enter key, press the Clear/Reset key to reset the
right display to the original temperature.
S If you enter a valid setpoint temperature for a hose/gun that is not
connected to the melter, the right display will indicate dashes (----) for
three seconds and then change back to the original setpoint
temperature.
S If you enter a setpoint temperature for a hose/gun that is out of range,
the right display will indicate dashes (----) for three seconds and then
change back to the original setpoint temperature.
S When scrolling through component numbers in the left display,
component numbers assigned to unused hose/gun receptacles are
skipped.
S The setpoint temperature of a component can be checked at any time
by pressing the right scroll key UP. The setpoint of every scanned
component is displayed when the scroll key is held down in normal
mode.
NOTE: Only the setpoint temperature of the reservoir is displayed and
not that of the grid, even if a temperature offset 0 0 was set.
To Next Page
Loading...
