Nordson PURBlue EC - Purging with Cleaning Agent

Maintenance
5-5
P/N 7135268B
E 2008 Nordson Corporation
PURBlue EC
Purging with Cleaning Agent
CAUTION: Use only a cleaning agent recommended by the hot melt
material manufacturer. Observe the Material Safety Data Sheet for the
cleaning agent.
Cleaning agent residue can be flushed out of the unit with new material
before production begins again. Refer to Controls Pump Speed and Purge
Mode / Purge in the section Operation.
NOTE: Properly dispose of cleaning agent according to local regulations.
Detaching Protective Panels
Open the protective panels with a 4 mm Allan key.
On the inside
Fig. 5-1