Operator’s manual
Optima 51 / M51 / M56 / M57T / 60T
8
Dynapôle Ludres/Fléville, 166 rue Ampère/BP 60093 - 54714 LUDRES - FRANCE - Tél.+33 (0)3 83 25 69 60 - Fax. +33 (0)3 83 26 12 85
3. Vibrations
To improve safety and health conditions of workers, the decree 2005-746 from July 4th, 2005 forces
the employer to evaluate the levels of exposure of its employees to the vibrations transmitted to the
whole body, and to start protection of the driver beyond exposure limit values.
These daily exposure limit values are precised in the article R 231-119 of the Labour regulation.
Noremat carried out trial runs to evaluate the level of vibrations emitted by a tractor /machine unit and
transmitted to the operator’s seat. As an indication, the median value recorded is 0.45m/s2 per eight
hours base period in normal work conditions as recommended by the manufacturer.
4. Heat
Take necessary precautions against the risks
due to the heat released by the hydraulic
components (hoses, pump, motor, gearbox,
valve block, rotor shaft).
Wear heat
protection
5. Delivery
Observe safety and handling rules, in particular:
-only use designated slinging points for all slings.
-never lift the machine with slings that are in poor condition or are too weak in lifting capacity.
-check that the means of lifting is satisfactory and suitable to lift the load.
-never stand or walk under the load.
-never attempt to remove the delivery supports (blue pieces) before tting
of the machine has been completed.
To Next Page
Loading...