Operator’s manual
Optima 51 / M51 / M56 / M57T / 60T
9
Dynapôle Ludres/Fléville, 166 rue Ampère/BP 60093 - 54714 LUDRES - FRANCE - Tél.+33 (0)3 83 25 69 60 - Fax. +33 (0)3 83 26 12 85
6. Before tting to the tractor/cv
-It is necessary that the tractor is equipped with a cab or means of protecting the driver from possible
debris thrown from the tool.
-Check the condition of the PTO shaft guard on the tractor.
-Carefully read the tting instructions supplied with the drive shaft.
-Check all tyre pressures.
7. Before starting the rotor
-Read chapter 2, section 3, ‘Identication of controls’.
-Read the operator’s manual for the tool to be used.
-Do not start the machine in an explosive atmosphere or near inammable items.
-It is recommended that the rst trial be carried out on ground which is rm, at and without obstacles.
-Ensure that the operator is familiar with the tractor/machine combination.
-Check that the control unit is mounted securely in the cab/on the tractor.
-Never start the rotor if anyone is standing within the trajectory of possible debris thrown from the rotor.
-Ensure that all persons remain outside of the working area of the tractor and machine.
-Never remove the front hood of the cutting tool during work when mowing (direction of rotor opposite
to the forward motion of the carrying vehicle, see chapter ‘User responsibilities’).
8. Before leaving the tractor/cv
Before leaving that tractor/cv or allowing anyone to approach, it is imperative to:
- lower the tool to the ground.
- stop the rotor.
- stop the PTO.
- switch the machine off.
- apply the parking brake.
- stop the tractor engine.
General Safety Rules
To Next Page
Loading...