44
CR60-IM.v0429.4
Installing Wall Mounted Rack without Optional Floor Support
1. Determine the desired position of the top of the rack
2. Mark this dimension along the wall
3. Measure down 44.0 in. and install a 2x4 wood piece of length to match the CR60 rack. This 2x4 must be
anchored at a maximum of every 18 in. This beam is used to help support the weight of the CR60 rack while
fastening.
4. Lift the CR60 rack and place on top the 2x4 bottom support
5. Anchor the CR60 rack to the wall using the general fastening instructions listed on pg. 40 of this manual.
6. Install another 2x4 wood support located at the top of the CR60 rack as shown below.
To Next Page
