53
CR60-IM.v0429.4
Electrical wiring
The units on the CR60 are not pre-wired. Each water heater requires 120VAC, 60Hz power from a properly
grounded circuit. For additional information please refer to the Water Heater Installation Manual and consult
with a qualified electrician.
• If using a power cord, plug it into a standard 3 prong 120VAC 60Hz properly grounded wall outlet.
• If using a disconnect switch, it must be installed for the incoming 120VAC power. It should be a type
suitable for outdoor use. Check your local codes for a proper switch type to use in your area.
To Next Page
