Noritz NCC199CDV - Automatic Recirculation Setup; Enabling Synchronized Recirculation

21
Enabling Automatic
Recirculation Operation
For “System [ Rcrc ]”
Enabling Automatic Recirculation Operation
• To check system status, see page 20.
• When “Synchro ON/OFF” is set to Yes,
recirculation can be activated automatically.
• To change “Synchro ON/OFF” from Yes to No,
follow the same procedure as described below.
2. Press the ENTER button.
5. Press the ENTER button.
4. Select “Yes” using the button.
3. Select “Synchro ON/OFF” using the /
buttons, and then press the ENTER button.
1. Press the MENU button inside the cover, select
“Recirc menu” using the / buttons.
Operation
• This adjustment can be made whether the
Power button is ON/OFF.
• If the display is left untouched for
approximately 20 seconds without pressing
the ENTER button, the setting will be
completed. When the Power button is turned
ON, the home screen will be restored.
The screen returns to the previous screen.