33
Remote Controller (RC-7649M and RC-7650M)
Display (RC-7649M)
Display
For setting the hot
water temperature,
the ow meter alarm,
and other settings.
Power On/O Button
For turning the
heater on and o.
Flow Meter Alarm Set Button
For setting the ow
meter alarm.
Setting Buttons
* Before use, remove the protective sheet from the remote controller surface.
* The unit has been shipped from the factory with the remote control set at 110°F.
Temperature Setting
(Ex.: 105°F)
Flow Meter Setting
The display will ash
after hitting the ow
meter alarm set button.
Error Code
When this indicator
is lit, the hot water
temperature can be
set.
Priority Indicator
The illustration below shows an example of the remote controller display.
What is actually displayed depends on how the water heater is set.
Burner On Indicator
A number will ash if a
failure occurs.
(Type RC-7649M)
Display (RC-7650M)
To Next Page
