NORPOLE NPPAC8KW - Operating Instructions; COOL operation; DRY operation; AUTO operation

7
(6) UP (▲) and DOWN (▼) buttons.
Used to adjust (increase/decrease) the temperature setting by increments of 2°F (1°C) between 62°F
(17°C) to 88°F (30)°C. Also used to adjust the TIMER setting between 0-24 hours.
NOTE: Temperatures can be displayed in either Fahrenheit or Celsius. To convert from one to the other,
press and hold the UP and DOWN buttons at the same time for 3 seconds.
(7) LED Display
Displays the set temperature in “°C” or “°F” and the TIMER settings. While on DRY and FAN modes, room
temperature is displayed.
Error codes:
E1 – Room temperature sensor error. Unplug the unit and plug back in. If error repeats, call for service
E2 – Evaporator temperature sensor error. Unplug the unit and plug back in. If error repeats, call for service
E4 – Display panel communication error. Unplug the unit and plug back in. If error repeats, call for service
P1 – Bottom tray is full. Connect the drain hose and drain the collected water. If error repeats, call for service
(8) SWING button (Applicable for models with AUTO SWING feature only)
Press the SWING button to turn this feature ON. Each time the SWING button is pressed, the louver will
angle up in 6° increments. Hold the SWING button down for 2 seconds to initiate the AUTO SWING
feature. During AUTO SWIGN, press the SWING button again to stop the louver at the desired angle.
OPERATING INSTRUCTIONS
COOL operation
- Press the MODE button until the COOL indicator light illuminates.
- Press the ADJUST buttons “↑” or “↓” to select your desired room temperature. The temperature can be
set within a range of 62°F (17°C) - 88°F (30°C).
- Press the FAN SPEED button to choose the desired fan speed.
DRY operation
- Press the MODE button until the DRY indicator light illuminates.
- Under this mode, you cannot select a fan speed or adjust the temperature. The fan motor will only
operate at a LOW speed.
- Keep windows and doors closed.
- Do not install the window duct.
AUTO operation
- In AUTO mode, the unit will automatically select COOLING, HEATING (on some models) or FAN ONLY
mode depending on the selected temperature setting and the room temperature.
- The air conditioner will automatically control the room temperature based on the selected temperature
setting.
- Under AUTO mode, you cannot select the fan speed.