10 6-050700 X2
212iLW & 242iLW Standalone Keypad
Installation & Programming Manual
5.4 Shunting a Normally Closed Zone
Use the following steps to use the keypad to shunt a normally closed
zone:
1. Connect the blue wire (common) to the common connection on
the door position switch.
2. Connect the green wire (normally open) to the normally closed
connection on the door position switch.
Figure 6. Wiring the Keypad to an Electric Strike (Fail-Secure)
Figure 7. Shunting a Normally Closed Zone
To Next Page
Loading...
