20 6-050700 X2
212iLW & 242iLW Standalone Keypad
Installation & Programming Manual
Command/Action Keys to Enter/Details
Command 32.
Change Keypad
Parameters
32 # parameter # value # ✱ ✱
Parameter Value
0 – Duress Output Duration 1 – 255 (default = 5)
1 – Panic Output Duration 1 – 255 (default = 5)
2 – Error Lockout Threshold 1 – 50 (default = 3)
3 – Error Lockout Duration 1 – 255 (default = 10
7.4 Programming Users
Command/Action Keys to Enter/Details
Master Code
User #1 is the master code; it can access all
commands in program mode. The default code
is 1234. The master code can be programmed
with Command 50 or Command 60 as a
standard user only.
Supervisor Code
User #2, when programmed, is the supervisor
code. The supervisor can access program mode,
but is limited to adding and deleting users,
as well as enabling or disabling users. The
supervisor code can’t change, delete, or disable
the master code or supervisor code itself.
Add Standard User
(short version)
user location # code ✱ code ✱
Add User with
Specifi c Unlock
Time
unlock time # user location # code ✱ code ✱
(This command is used to program a user with
a specifi c unlock. This user activates the virtual
lock output.)
Delete User
user location # ✱ ✱
To Next Page
Loading...
