6-050700 X2 15
212iLW & 242iLW Standalone Keypad
Installation & Programming Manual
6. Testing the Keypad
After installing the keypad, the manufacturer recommends that you
perform the keypad self-test once a year, to ensure that the keypad
works properly.
1. To perform the self-test, with the unit powered up, press the
following keys on the keypad: 7890 # 123456 ✱
● If all 12 key presses are accepted, the keypad enters self-test
mode.
● The LEDs alternate green, yellow, and red followed by the
sounder beeping three times.
2. Verify that the master code works correctly. (The master code
accesses program mode and activates the main relay to verify
that the locking device is working.)
The default master code is 1234.
(If the default is not working, refer to Section 9.)
To Next Page
Loading...
