Nortek 2GIG GC3 - Screen

Copyright © 2019 Nortek Security & Control LLC.
67
Screen
Use the Screen feature to adjust the screen brightness,
dim brightness, backlight timeout, screensaver features,
and to place the touchscreen into Clean Mode.
NOTE: To use this feature, you must know the four-
digit Master User Code.
Navigating to Screen
1. At the Home screen, tap System Settings.
Home Screen > System Settings
2. At the Enter Your Code to Access the System
Settings screen, enter an active, four-digit user
code.
Enter Your Code to Access the System Settings
3. At the System Settings menu, tap Screen.
System Settings > Screen
This reveals the Screen screen.
Adjusting the Screen Brightness
Adjust the screen brightness to improve the readability of
the text and images on the touchscreen and to avoid eye
discomfort in darker environments or at night.
To adjust the screen brightness:
1. Navigate to Screen. See “Navigating to Screen” in
the previous section.
2. Swipe the Screen Brightness slide control to the
left or right to decrease or increase the brightness.
Screen—Screen Brightness
3. Tap to return to the System Settings menu.
4. Tap to return to the Home screen.
Adjusting the Dim Brightness
NOTE: This feature is available only when the
system is set to demo mode.
The Dim Brightness refers to the brightness level of the
touchscreen when backlit.
To adjust the Dim Brightness:
1. Navigate to Screen. See “Navigating to Screen” on
the previous page.
2. On the Dim Brightness slide control, swipe left to
lower the dimmer brightness. Swipe right to increase
the dimmer brightness.