Nortek 2GIG GC3 - Replacing Cellular Radio Module

Copyright © 2019 Nortek Security & Control LLC
78
Cell Radio Swap
3. Tap Begin.
Begin
4. Remove the hinged door from the GC3e Control
Panel.
Remove Hinged Door
5. Pull the tab to remove the Cellular Radio Module.
6. Insert the Cellular Radio Module until it clicks into
place and select Done.
4. Select the Edit icon for Gateway and enter the
desired Gateway Address.
Gateway Address
5. Select the Edit icon for DNS Server and enter the
desired DNS Server Address.
6. Tap Confi gure Network Settings.
Replace the GC3e Cellular Radio Module
After your system is installed, if your dealer supplies you
with a new 2GIG cellular radio module, you can use the
following instructions to install it into your GC2 Control
Panel.
To replace the Cellular Radio Module into a system:
1. From the Home screen, tap System Settings.
2. From the System Settings menu, tap Cell Radio
Swap.