Nortek 2GIG GC3 - Performing System Tests; Performing Sensors Test; Performing Console Test

To Next Page

To Previous Page

Performing a Sensors Test

To perform a sensors test:

1. Navigate to the System Tests menu. See “Navigate

to System Tests.”

Sensors Test

2. Tap Sensors Test.

This places the GC3e Panel into Walk Test Mode

and transmits a Walk Test Started report to the

Central Station.

3. At the Sensors Test screen, review the list of

sensors installed with your system.

4. Walk to and trigger each sensor in the list:

For Door/Window Contact Sensors: Open and

then close the door or window.

For Motion Detectors: Stay outside of the

protected area for ﬁ ve (5) minutes. Then, walk

through the area.

For Panic Buttons, Keyfobs, and Wireless

Keypads: Press a key or button on the device.

For Smoke/Heat/Freeze Alarms, Carbon

Monoxide Detectors, or Glass Break Detectors:

Press the product’s Test button. See the Installation

Instructions that came with the product for help

locating the test button.

Successful Tests - GREEN Bar

When tests are successful, a GREEN bar appears to the

left of the test name. This indicates the sensor is operating

and the wireless signal strength was good.

WARNING!! If a

RED bar appears, it indicates

the test failed. To protect your dwelling and its

occupants from adverse events, contact your 2GIG

alarm dealer for technical assistance.

5. Tap the

button.

Performing a Console Test

To perform a console test:

1. Navigate to the System Tests menu. See “Navigate

to System Tests.”

2. Tap Console Test.

This reveals the Console Test screen.

Other manuals for Nortek 2GIG GC3