Nortel 8600 - Page 22

22 Installing the chassis
Step Action
1
Align the mounting retainers on the inside of the top
cable-management bracket with the holes on the front of the chassis.
2
Push the sides of the top cable-management bracket in place.
3
Insert and tighten the 8 screws using a Phillips screwdriver to secure
the top cable-management bracket to the chassis.
—End—
To install the two side cable-management brackets:
Step Action
1
Align the slots on the side bracket with the rods in the chassis.
2
Push the bracket into place.
Figure 9 "Installing cable-management brackets" (page 23) shows
the installation of both the top and side cable-management brackets.
Nortel Ethernet Routing Switch 8600
Quick Start
NN46205-310 01.01 Standard
4.1 21 December 2006
Copyright © 2006 , Nortel Networks Nortel Networks Confidential
.