Grounding the 8010co chassis 23
Figure 9
Installing cable-management brackets
—End—
Grounding the 8010co chassis
Before you connect power cables or network cables to your switch, Nortel
recommends that you ground the 8010co chassis. Figure 10 "Location of
ground studs on 8010co chassis rear panel" (page 24) shows the location of
the ground studs on the 8010co chassis rear panel.
Nortel Ethernet Routing Switch 8600
Quick Start
NN46205-310 01.01 Standard
4.1 21 December 2006
Copyright © 2006 , Nortel Networks Nortel Networks Confidential
.
To Next Page
Loading...
