215658-B
8
This guide includes information about the following topics:
• “Before you begin” (next)
• “Package contents for the BayStack 425 switch” on page 9
• “Installing the switch on a table or shelf” on page 10
• “Installing the switch in an equipment rack” on page 11
• “Connection requirements” on page 12
• “Connecting AC power” on page 14
• “Checking LEDs” on page 18
• “Initial switch setup” on page 20
• “Related publications” on page 24
Before you begin
Make sure the area where you will install and use the BayStack 425 meets these
environmental requirements:
• Ambient temperature between 32° and 104° F (0° and 40° C)
• Relative humidity between 10% and 85% noncondensing
• No nearby heat sources such as hot air vents or direct sunlight
• No nearby sources of severe electromagnetic noise
• No excessive dust
• Adequate power source within six feet; one 15-Amp circuit required for each
unit.
• At least 2 inches (5.08 cm) on each side of the switch unit for ventilation.
• Adequate space at the front and rear of the switch for access to cables.
If you are installing a single BayStack 425 on a table or shelf, make sure the
surface will support at least 10 to 15 pounds (4.5 to 6.8 kilograms).
book.book Page 8 Thursday, July 29, 2004 10:07 PM
To Next Page
Loading...
