Page 310 of 504 Analog (500/2500-type) telephones
553-3001-367 Standard 3.00 August 2005
Note: Do not remove the circuit card if any remaining units on the card
are assigned.
Procedure 54
Installing an analog (500/2500-type) telephone
1 Ensure that the wiring is installed at the telephone’s location.
2 Unpack and inspect the telephone for damage. Assemble the handset
and line cords if necessary.
3 Install the required designations on the telephone.
4 Connect the telephone to the TELADAPT connector.
5 Cross-connect the telephone wiring at the cross-connect terminal.
6 Configure the telephone in the system. Refer to the Software Input/
Output: Administration (553-3001-311).
End of Procedure
Follow the steps in Procedure 55 to remove an analog (500/2500-type)
telephone.
Procedure 55
Removing an analog (500/2500-type) telephone
1 Remove telephone data from the system. Refer to the Software Input/
Output: Administration (553-3001-311).
2 Disconnect the telephone from the TELADAPT connector.
3 Pack the telephone in a container.
4 If necessary, remove the cross-connections for the telephone at the
cross-connect terminal.
5 Remove the line circuit card if required. Refer to Circuit Card: Description
and Installation (553-3001-211).
End of Procedure
Designate 500-type telephones
Follow the steps in Procedure 56 to designate analog 500-type telephones:
To Next Page