Remark:
1. The minimum time is 1 minute and the maximum is 8 hours (setting time display: 00:01,
running time:00:01:00,00:00:59)
2. The target time has been set on the current interface. When the target time is completed,
it will display a full grid (full circle.At this time, the whole circle flashes, and a 20-second
beep is issued at the same time "Bl, BI, BI" beeps. buzzing and flashing During the process,
press any key to stop the beeping and flashing
3. Press the S2 key to query the step counting data at the current time: steps, calories, walking
kilometers and average time speed,
4. When step counting is turned on, trigger step counting for 15 consecutive steps, the step
counting icon flashes, and the time starts counting, and the number of steps is included
in the total number of steps, if it is less than 15 consecutive steps, the step counting will
not be triggered, and the number of steps will not be counted Enter the total number;
in the process of step counting, if there is no continuous movement or does not move,
it will enter the step counting sleep state The power status and time will also be suspended.
5. Short press the S3 key to reset in the pause state (restore to the single step counting
interface)
6. After long pressing the S3 key to return to other interfaces, if the target time is completed,
enter the single count again In the step mode, it will directly jump to the time end interface.
7. There is no automatic return function for a single exercise, long press the S3 key to return.
12
12
To Next Page
Loading...
