Why are satellite signals often lost on my NorthStar GPS 6000i?
If you're losing satellite signals, especially when traveling in one direction but not the opposite, the antenna may be partially shaded by metallic objects. Try re-positioning or raising the antenna for a better view of the sky. Also, signals can be lost under bridges or when shielded by buildings.
What to do if the NorthStar GPS 6000i powers up, beeps, but there is no video?
If your NorthStar GPS 6000i powers on and beeps but shows no video, the input voltage may be too low. Also, the display itself might have failed.
What to do if the NorthStar 6000i GPS system locks up when using a chart card?
If your NorthStar GPS system freezes when you use a chart card, the card could be faulty. Remove the card and check both the card's pin area and the 6000i for any damage. If the pins in the 6000i are bent, don't insert another card to prevent further damage. If the pins are okay, try inserting a new card after turning the power off.
How to fix color bars appearing on NorthStar GPS 6000i instead of video overlay?
If color bars appear instead of the video overlay image on your NorthStar GPS 6000i, check the video cables and connectors. Also, make sure the video equipment is working correctly.
What to do if the NorthStar GPS display screen dims?
If the display screen dims after your NorthStar GPS 6000i has been on for a while, it may be in auto-dimming mode. This feature helps protect the display and reduces power use when the 6000i gets too hot.
How to obtain WAAS satellites on NorthStar GPS 6000i?
To obtain WAAS satellites on your NorthStar GPS 6000i, verify that WAAS is available in your current area. Then, reset the satellite elevation setting to the default of 5 degrees and ensure that the DIFFERENTIAL OPTIONS setting is set to WAAS.
Why pressing PWR doesn’t start the NorthStar GPS 6000i?
If pressing the PWR button doesn't start your NorthStar GPS 6000i, check the fuse and the power supply to the 6000i. Also, make sure you are pressing the PWR button briefly to turn the system on.
What to do if the NorthStar GPS 6000i gives poor SNR readings?
To improve SNR readings on your NorthStar GPS 6000i, check the antenna's location to ensure it has a clear view of the sky. Also, make sure the antenna is clean and free from ice, snow, or exhaust soot.
To Next Page
General
