16
2. Check Fuel: Fill if low. Use only unleaded gasoline with a pump sticker
octane rating of 86 or higher is recommended. Never use an oil and gasoline
mixture!
3. Air Cleaner: Never run the engine without the air cleaner! Rapid engine wear
will result from contaminants being drawn through the carburetor and into the
engine.
4. Engine Starting: Refer to the engine owner's manual for proper engine
starting procedure.
The head on the Gasoline Powered Saw should only rise to a
maximum of nine (9) inches above the surface of the Cutting
Table
For any Engine service, warranty, or technical related questions please contact
your nearest Honda service centers:
Honda Power Equipment Group
4900 Marconi Dr.
Alpharetta, GA 30005-8847
Tel: (800) 426-7701
Fax: (678) 339-2670
Web page: http://www.honda-engines.com/dis.htm
To Next Page
Loading...
