21
B. Electric Motor
The motors are specially designed for masonry sawing. It is totally enclosed and
the sealed bearings require no lubrication. The motor is equipped with thermal
overload protection.
1. Periodically clean the dirt and sludge build-up from the motor fan housing and
cooling fins.
2. If the motor becomes overheated, the protector shuts the motor off. Turn the
motor switch to the "OFF" and identify the cause of overheating.
For any Electric Motor service, warranty, or technical related questions please
contact your nearest Baldor service center:
Baldor Electric Company
Corporate Headquarters
5711 R.S. Boreham, Jr. St.
P.O. Box 2400
Fort Smith, AR 72901
Phone: (501) 646-4711
Fax: (501) 648-5792
Web Page: http://www.baldor.com/support/default.asp
C. Engine
1. Refer to the engine owner’s manual for complete maintenance.
a. Pre-cleaner: every 25 operating hours, more often in dusty or dirty conditions,
wash and oil the pre-cleaner.
b. Paper Element: Every 100 operating hours, more often under dusty or dirty
conditions, clean the paper element.
To Next Page
Loading...
