22
c. Engine Oil: After the first month or 20 operating hours, change the oil, then
every 6 months or 100 operating hours.
For any Engine service, warranty, or technical related questions please contact
your nearest Honda service centers:
Honda Power Equipment Group
4900 Marconi Dr.
Alpharetta, GA 30005-8847
Tel: (800) 426-7701
Fax: (678) 339-2670
Web page: http://www.honda-engines.com/dis.htm
D. Blade Shaft Bearings
The blade shaft bearings are lubricated and should not require daily lubrication
under normal conditions. However, to assure long life the bearings do need to be
lubricated periodically. The time interval between greasing is dependent on the
running speed and operating conditions. The following chart covers most
situations and can be used as a guide.
Temperature Cleanliness Greasing Interval
*UP TO 150°F Dirty 6 to 12 months
Over 150°F Dirty Daily to 2 Weeks
Any Temp Very Dirty Daily to 2 Weeks
Any Temp Extreme Conditions Daily to 2 Weeks
NOTE: Never operate saw without bearing cover in place.
For normal conditions the grease should conform to the NLGI grade two
consistency and be free of any chemical impurities such as free acid or free alkali,
dust, rust, metal particles or abrasives.
For best results, the bearings should be lubricated while in operation.
NOTE: Due caution for personal safety must be observed when servicing rotating
equipment.
If necessary to lubricate while the bearing is idle, refer to lubrication table for the
maximum grease capacity for the bearings.
E. Water Pump
The submersible water pumps for all BBL Electrical and Gasoline powered
machine’s do not require any lubrication.
To Next Page
Loading...
