78
Part Specification Installation Position Quantity
Bearing cap 2
75×2.65G
External end of half shaft
sleeve
2
80×3.55G Rear bearing 2
85×3.55G
Driving bevel gear bearing
saddle
2
170×3.55G Drive shaft cap 2
175×3.55G
Internal end of half shaft
sleeve
2
NOTICE: Before using a supporting farm implement, the owner/operator should read the machines
“operation and maintenance manual” carefully and become familiar with the construction, performance and
method of operation to avoid machine damage and personal injury caused by accident.
IMPORTANT NOTES:
1. Before purchasing farm machines and implements, select a good match with your machine or
consult a reputable dealer. Understand your operational conditions (soil resistance, agricultural
requirements, etc.) of the areas where you will be working and referring to this list.
2. Determine the main technical parameters of the farm machines and implements such as models
according to the operational conditions (soil resistance, agricultural requirements, etc.) of the areas
where you will working and refer to the advisories in order to get the appropriate match. Improper
matching will make the new machinery ineffective and, possibly, dangerous.
3. Working efficiency can be dependent on the implement, the performance of which may vary
with operational conditions (soil resistance, agricultural requirements, etc.). Therefore, you
should determine working speed and width, etc. and make your purchase accordingly.
Distributed by Northern Tool + Equipment Co., Inc.
Burnsville, MN 55306-6936
Made in China
To Next Page
Loading...
