Notifier AFC-600 - 3. How to Operate the Control Panel; Section Overview

6HWWLQJ 351 2SWLRQV
Refer to the documentation supplied with the PRN-5 for instructions on using the printer menu
controls. Set the printer options (under the menu area) according to the settings listed below:
7DEOH  351 6HWXS 2SWLRQV
,QVWDOOLQJD.HOWURQ3ULQWHU
Connect the remote printer to the CPU-600 as follows:
Option Setting
L/R Adjust
Font
LPI
ESC Character
Bidirectional Copy
0
HS Draft
6 CPI
ESC
ON
CG-TAB
Country
Auto CR
Graphic
E-USE ASCII
1S
Color Option
Formlen
Lines
Standard
Not Installed
6 LPI-60
Executive 10.5"
CPI
Skip
Emulate
I/O
Buffer
Serial
Baud
Format
Protocol
Character Set
S1. Zero
Auto LF
MENULOCK
PAPER
BIN 1
BIN 2
SINGLE
PUSH TRA
PULL TRA
PAP ROLL
PAPOPT
10 CPI
0.5
Epson
36K
9600
7 Bit, Even, 1 Stop
XON/XOFF
Standard
On
Off
12/72"
12/72"
12/72"
12/72"
12/72"
12/72"
No
Step Action
1 Connect the three (3) open leads of the custom cable to the TB1 terminal
block on the CPU-600 as shown in the figure below.
2 Connect DC power from TB2 terminal block on the MPS-6 power supply as
shown in the figure below.
3 Plug the DB-25 connector end of the custom cable into the EIA-232 port of
the Keltron printer. Tighten securely.
Installing Remote Printers and a CRT  ,QVWDOODWLRQ
AFC-600 Installation PN 51031:B 03/28/2001 73
Technical Manuals Online! - http://www.tech-man.com